Spring Maintenance Tips For Your Furnace

Your furnace is one of the most important parts of your home HVAC system. It keeps you warm in the winter and cools in the summer, but it also needs some care and maintenance to stay in tip-top shape. Spring is a great time to give your furnace a little love and attention. Keep reading to learn some maintenance tips that will help you keep your heating and cooling services running smoothly and safely all year long.

Clean The Furnace

Spring is the best time of year to perform a full cleaning and maintenance routine for your furnace. This will help your furnace run efficiently, keep your home warmer, and prevent problems in the future. A good furnace cleaner will remove dust, debris, and sludge from your furnace’s internal components. Keeping your furnace clean and free of blockages will ensure that it runs as efficiently as possible, so you won’t have to worry about paying more for fuel than necessary or costly heating repairs.

Change The Air Filter

Changing your air filter is one of the most important preventive maintenance tasks you can do for your furnace. Not only does it improve your indoor air quality, but it can also save you money by improving the efficiency of your AC and furnace. Typically, the air filter is located between the ductwork that brings air in from the house and the internal blower unit of your furnace or air handler (it can be found inside these units too). In some cases it can be difficult to find, because of the location of the system. If you do not know where your current filter is, locate it by looking in the return air duct near the furnace or indoor unit (it can be found in basements, crawl spaces, garages and attics). There may be an access door on this duct that will allow you to remove the existing filter and replace it with a new one.

Check The Thermostat

Your thermostat is one of the most critical parts of your heating and cooling system. It should deliver trouble-free service over many years. However, like any manufactured product, it can fail and leave you without heat or cool air. Fortunately, you can test your thermostat to see if it’s working properly. To do this, find the two wires that connect it to your furnace and undo their terminals with a screwdriver. Once you’ve removed them, twist each wire together and see if the blower starts when you turn your home’s circuit breaker back on. If your thermostat doesn’t start the blower after you do this, it might be faulty and needs to be replaced. If your furnace has a manual pilot light, make sure it is lit by lighting a match over the pilot orifice while holding down the reset button for 60 seconds. If this doesn’t work, contact us for assistance.